Designed to replace your lower shift lever for Sram X01 and XX1 shifters, this lever is adjustable and gets you rocking the matchy-match cockpit. Made with the Loam Lever’s “yoga pad for your thumb” this guy is that extra bit of style to make you smile each time you hop on your bike.
DON'T MISS A SHIFT
Lifetime Warranty
We've always got
your back
Fast Shipping Options
Get your parts for the
weekend ride
Unparalleled Service
Seriously, we're here
for you
Pacific NW Approved
All Season reliability, tested in the mountains
How Does Travel Adjust work?
Our travel adjust system allows for a total of 30mm travel reduction in 5mm increments. If you were riding that line between travel sizes you can now fine-tune the perfect fit by following the easy directions below:
- Begin by lowering your dropper at or below the desired travel length (just make sure it’s not fully extended!)
- Unthread the midcap with your hand and slide it up to reveal the white DU Bushing.
- You’ll see negative numbers with corresponding notches machined into the post (each # represents decreasing travel.
- Slide the DU bushing up and rotate it to align the black arrow with the amount of travel you would like to reduce, then seat the arrow into the machined groove. (Make sure it’s fit securely into these notches!)
- After pushing the DU Bushing back down, lower the midcap and hand tighten (no need to go overboard!) and ride off into the sunset with the perfect travel for you.
How Does Travel Adjust work?
Our travel adjust system allows for a total of 30mm travel reduction in 5mm increments. If you were riding that line between travel sizes you can now fine-tune the perfect fit by following the easy directions below:
- Begin by lowering your dropper at or below the desired travel length (just make sure it’s not fully extended!)
- Unthread the midcap with your hand and slide it up to reveal the white DU Bushing.
- You’ll see negative numbers with corresponding notches machined into the post (each # represents decreasing travel.
- Slide the DU bushing up and rotate it to align the black arrow with the amount of travel you would like to reduce, then seat the arrow into the machined groove. (Make sure it’s fit securely into these notches!)
- After pushing the DU Bushing back down, lower the midcap and hand tighten (no need to go overboard!) and ride off into the sunset with the perfect travel for you.
Specs: shifty lever
compatibility
only compatible with Sram X01 and XX1 Shifters.
Shifty lever is to replace Sram's lower Pull Lever only
WEIGHT
16g (SRAM X01 lever is 13g)
Kit includes
Cables and housing
install tips
- Remove the smaller Torx (T25) screw that clamps the lever onto the lever (NOT the bolt on the bottom of the shifter) completely from your Sram X01 or XX1 shifter
- Remove lever off of the round assembly on the shifter body
- Make sure the fastener is removed out of the Shifter Lever so that it can be slid onto the round assembly of the shifter body
- Once the Shifter Lever is slid over the round assembly, thread the fastener in and now you can line the indicator line on the Shifter Lever with where you want it positioned on the shifter. This will help with reach placement.
- After finding the desired positioning, torque the fastener to 2Nm using a torque wrench
- Play around with angles to get the right fit for you and you're ready to ride!
Warranty
PNW Lifetime Warranty
Do we have your back? Of course. If anything goes wrong, we're here to do everything we can to ensure you're taken care of.